+86-17895376160

24/7 Customer Support

bruce@aluminaceramicball.com

Reply within 12hours

Mon - Fri: 9:00 - 17:30

Online store always open

Tabular corundum production process

As a large-scale important raw material of refractory materials, tabular corundum is produced by using a high-temperature shaft kiln to produce sintered tabular corundum, which is characterized by the following process steps.
1. Ball milling. Using Bayer process light-burned alumina powder as the raw material for continuous ball milling, the fineness and specific surface area must meet the requirements, which will help the sintering and densification of the alumina powder.

2. Into the ball. The ground powder is made into a ball using a ball disk or a ball tube. The formed pellets must have strength to avoid breakage during transport to the dryer. In the process of pelletizing, the semi-finished pellets have high water content, easy layering, and difficult drying problems. The corresponding process optimization design is carried out and properly solved.
3. Dry. The formed green balls are put into the dryer. The countercurrent hot air in the shaft kiln is used for drying to remove about 15% (w) of moisture. However, the temperature in the shaft kiln must be strictly controlled to avoid cracks and stratification, or even agglomeration and blockage in the billet, which will cause the interruption of the ball flow and the deterioration of the drying quality.
4. Sintering. The green balls enter the shaft kiln after drying. The sintering temperature is 1900`1950°C. By controlling the temperature and flow rate of the hot air in the shaft kiln, a plate-like corundum structure with fully developed and sintered crystals is obtained.
After sintering, after cooling, sorting, inspection, crushing and screening, products of different particle sizes can be obtained.

You May Also Enjoy these Article for alumina product

The difference between sintered corundum and tabular alumina

1.Sintered alumina Sintered alumina is also called sintered corundum. It is a refractory clinker made of calcined alumina or industrial alumina powder as raw material, finely ground into balls or green bodies, and sintered at a high temperature of 1750-1900°C. Sintered alumina with a W(Al2O3) over 99% is mostly made of uniform fine-grained corundum directly

Read More »

The use of sintered tabular corundum in refractories

The properties of tabular corundum have many applications in the field of refractories. Mainly used in the steel industry. Tabular corundum is an ideal material containing 90% alumina for high alumina bricks and amorphous linings. Tabular corundum is suitable for ceramic, chemical and water-bound substrates. Plate corundum can be used alone and in combination, or

Read More »

What are the applications of Tabular Alumina

Tabular corundum is a pure, sintered corundum that is fired without adding any additives such as MgO, B2O3, etc. It has a coarse, well-developed α-Al2O3 crystal structure, and the content of Al2O3 is more than 99%. So what are the applications of tabular corundum? The editor of Henan Sicheng provides detailed answers for everyone. Plate-like

Read More »

 Alumina grinding columns are widely used in different types of ceramics, enamels, glass, chemicals, etc. 

Popular Article List

June 2024
M T W T F S S
 12
3456789
10111213141516
17181920212223
24252627282930
Scroll to Top